Local Control Keys - Danfoss FC 300 Design Manual

FC 300 Design Guide
Status Mode:Displays the status of the adjustable
frequency drive or motor.
If an alarm occurs, the NLCP automatically
switches to status mode.
A number of alarms can be displayed.
NOTE
Parameter copy is not possible with LCP
101 numerical local control panel.
Par. No. Parameter Description
1-20 Motor Power
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
5-12 Terminal 27 Digital Input
3-02 Minimum Reference
3-03 Maximum Reference
3-41 Ramp 1 Ramp-up Time
3-42 Ramp 1 Ramp-down Time
3-13 Reference Site
1-29 Automatic Motor Adaptation, AMA
Main Menu is used for programming all parameters.
The parameter values can be changed using the
up/down arrows when the value is flashing.
Select the main menu by pressing the
[Menu] key several times.
Select the parameter group [xx-__] and press [OK].
Select the parameter [__-xx] and press [OK].
If the parameter is an array parameter, select
the array number and press [OK].
Select the desired data value and press [OK].
[Back] for stepping backwards.
Arrow [∧] [∨] keys are used for navigating
between commands and within parameters.

Local Control Keys

"
Keys for local control are found at the bottom
of the control panel.
How to Program
MG.33.B6.22 - VLT is a registered Danfoss trademark
Unit
kW
V
Hz
A
[0] No function
rpm
rpm
sec
sec
[1] Enable complete AMA
147