Parameter Set-Up; Quick Menu Key Functions - Danfoss FC 300 Design Manual

FC 300 Design Guide
Status screen II:
See the operating variables (1.1, 1.2, 1.3, and 2)
shown in the screen in this illustration.
In the example, Speed, Motor current, Motor
power and Frequency are selected as variables
in the first and second.
Status screen III:
This state displays the event and action of the
Smart Logic Controller. For further information,
see section Smart Logic Controller.

Parameter Set-Up

"
The FC 300 Series can be used for practically all assignments, which is why the number of parameters is quite
large. The series offers a choice between two programming modes - a Main Menu and a Quick Menu mode.
The former provides access to all parameters. The latter takes the user through a few parameters
making it possible to start operating the adjustable frequency drive.
Regardless of the mode of programming, you can change a parameter both in the Main
Menu mode and in the Quick Menu mode.

Quick Menu Key Functions

"
Pressing [Quick Menus] The list indicates the
different areas contained in the Quick menu.
Select My personal menu to display the chosen
personal parameters. These parameters are
selected in par. 0-25 My Personal Menu. Up to 20
different parameters can be added in this menu.
Select Quick setup to go through a limited number of parameters to get the motor running almost
optimally. The default setting for the other parameters considers the desired control functions
and the configuration of signal inputs/outputs (control terminals).
Parameters are selected by using the arrow keys. The parameters in the following table are accessible.
How to Program
MG.33.B6.22 - VLT is a registered Danfoss trademark
1.1
1.3
1.2
2
141