Quick Transfer Of Parameter Settings - Danfoss FC 300 Design Manual

FC 300 Design Guide

Quick Transfer of Parameter Settings

"
Once the set-up of a drive is complete, we
recommend that you store the data in the LCP or
on a PC via the MCT 10 Set-up Software Tool.
Data storage in LCP:
1. Go to par. 0-50 LCP Copy
Press the [OK] key.
2.
Select "All to LCP"
3.
Press the [OK] key.
4.
All the parameter settings are now being stored in the LCP as indicated by the progress
bar. When 100% is reached, press [OK].
NOTE
Stop the motor before performing this operation.
You can now connect the LCP to another adjustable frequency drive and copy the parameter
settings to this adjustable frequency drive as well.
Data transfer from LCP to drive:
Go to par. 0-50 LCP Copy
1.
Press the [OK] key.
2.
Select "All from LCP"
3.
4. Press the [OK] key.
The parameter settings stored in the LCP are now transferred to the drive indicated by
the progress bar. When 100% is reached, press [OK].
NOTE
Stop the motor before performing this operation.
How to Program
MG.33.B6.22 - VLT is a registered Danfoss trademark
139