Danfoss FC 300 Design Manual page 215

FC 300 Design Guide
Function:
Select control of the frequency converter
set-up selection via the terminals (digital
input) and/or via the fieldbus.
Select Bus [1], to activate the set-up selection via
the serial communication port or fieldbus option.
Select Logic AND [2] to activate the set-up selection
via the fieldbus/serial communication port, AND
additionally via one of the digital inputs.
Select Logic OR [3] to activate the set-up selection
via the fieldbus/serial communication port OR
via one of the digital inputs.
NOTE
This parameter is active only when
par. 8-01 Control Site is set to [0]
Digital and control word.
8-56 Preset Reference Select
Option:
Digital input
Bus
Logic AND
*
Logic OR
Function:
Select control of the frequency converter Preset
Reference selection via the terminals (digital
input) and/or via the fieldbus.
Select Bus [1], to activate the Preset Reference
selection via the serial communication port
or fieldbus option.
Select Logic AND [2] to activate the Preset Reference
selection via the fieldbus/serial communication port,
AND additionally via one of the digital inputs.
Select Logic OR [3] to activate the Preset Reference
selection via the fieldbus/serial communication
port OR via one of the digital inputs.
NOTE
This parameter is active only when
par. 8-01 Control Site is set to [0]
Digital and control word.
8-9* Bus Jog
"
Parameters for configuring the Bus Jog.
8-90 Bus Jog 1 Speed
Range:
0 - par. 4-13 RPM
* default setting ( )
How to Program
[0]
[1]
[2]
[3]
*
100RPM
display text [ ] value for use in communication via serial communication port
MG.33.B6.22 - VLT is a registered Danfoss trademark
Function:
Enter the jog speed. This is a fixed jog speed
activated via the serial port or fieldbus option.
8-91 Bus Jog 2 Speed
Range:
0 - par. 4-13 RPM
Function:
Enter the jog speed. This is a fixed jog speed
activated via the serial port or fieldbus option.
*
200RPM
215