The Fc 300 Software Dialog - Danfoss FC 300 Design Manual

FC 300 Design Guide

The FC 300 Software Dialog

"
Data storage in PC via MCT 10 Set-Up Software:
Connect a PC to the unit via USB com port
1.
2. MCT 10 Set-up Software
Choose "Read from drive"
3.
Choose "Save as"
4.
All parameters are now stored.
How to Install
Data transfer from PC to drive via MCT
10 Set-Up Software:
1.
2.
3.
4.
5.
All parameters are now transferred to the drive.
A separate manual for MCT 10 Set-up
Software is available.
MG.33.B6.22 - VLT is a registered Danfoss trademark
Connect a PC to the unit via USB com port
MCT 10 Set-up Software
Choose "Open" - stored files will be shown
Open the appropriate file
Choose "Write to drive"
119