Danfoss FC 300 Design Manual page 23

FC 300 Design Guide
Hand Off
Auto
LCP Keys
Hand
Hand -> Off
Auto
Auto -> Off
All keys
All keys
The table shows under which conditions either the local reference or the remote reference is active.
One of them is always active, but both cannot be active at the same time.
Par. 1-00 Configuration Mode determines what kind of application control principle (i.e., speed, torque or
process control) is used when the remote reference is active (see table above for the conditions).
Par. 1-05 Local Mode Configuration determines the kind of application control principle
that is used when the local reference is made activate.
Reference Handling
Local Reference
Introduction to FC 300
Reference Site
Par. 3-13
Linked to Hand / Auto
Linked to Hand / Auto
Linked to Hand / Auto
Linked to Hand / Auto
Local
Remote
MG.33.B6.22 - VLT is a registered Danfoss trademark
Active Reference
Local
Local
Remote
Remote
Local
Remote
23