Changing Of Data Value, Step-By-Step; Read-Out And Programming Of Indexed Parameters - Danfoss FC 300 Design Manual

FC 300 Design Guide

Changing of Data Value, Step-by-Step

"
Certain parameters can be changed step-by-step or infinitely variably. This applies to Motor Power
(par. 1-20), Motor Voltage (par. 1-22) and Motor Frequency (par. 1-23).
The parameters are changed both as a group of numeric data values and as nu-
meric data values infinitely variably.
Read-out and Programming of In-
"
dexed Parameters
Parameters are indexed when placed in a rolling stack.
Par. 15-30 to 15-32 contain a fault log which can be read out. Choose a parameter, press [OK],
and use the up/down navigation keys to scroll through the value log.
Use par. 3-10 as another example:
Choose the parameter, press [OK], and use the up/down navigation keys to scroll through the
indexed values. To change the parameter value, select the indexed value and press [OK].
Change the value by using the up/down keys. Press [OK] to accept the new setting. Press
[CANCEL] to abort. Press [Back] to leave the parameter.
How to Program
MG.33.B6.22 - VLT is a registered Danfoss trademark
145