Electrical Installation, Control Terminals - Danfoss FC 300 Design Manual

FC 300 Design Guide
Control terminals (all enclosures)

Electrical Installation, Control Terminals

"
To mount the cable to the terminal:
Strip isolation of 0.34-0.39 in [9-10 mm]
1.
2. Insert a screwdriver in the square hole.
Insert the cable in the adjacent circular hole.
3.
Remove the screwdriver. The cable is now
4.
mounted to the terminal.
To remove the cable from the terminal:
Insert a screwdriver in the square hole.
1.
Pull out the cable.
2.
Assembling IP 55 / NEMA TYPE 12 (A5 housing)
with line supply disconnector
106
How to Install
MG.33.B6.22 - VLT is a registered Danfoss trademark
1. 2.
3.