Setting Up The 882 For Hdmi Testing - Quantum Data 881 User Manual

Setting up the 882 for HDMI testing

882 Video Test Instrument User Guide (Rev A.35)
This section provides general procedures for setting up the 882 for HDMI testing. The
procedures below can be performed using the front panel or the command line interface.
To set up the 882 for HDMI testing:
1. Connect an HDMI-to-HDMI cable between the HDMI display device under test and the
either one of the HDMI OUT connectors on the 882.
2. Activate the HDMI-H interface on the output port:
a. Press the Interface key to access the list of interfaces. A listing of signal interfaces
appears on the 882's display as shown below.
VGA
*
HDMI-D
HDMI-H
b. Choose the HDMI-H item by pressing the adjacent soft key.
The interface is activated and the port outputs the currently selected image and format.
VGA
HDMI-D
*HDMI-H
Alternatively, to select the interface through the command line, enter the following
commands:
XVSI 4 // Selects the HDMI-H interface
ALLU // Applies the interface setting to the 882
3. (Optional) Disable the second HDMI output:
a. Press the Options key. The following information appears on the 882's display.
+Output
b. Disable the second output by pressing the soft key adjacent to the Disable 2 option.
A + appears next to Disable 2 option, indicating it is enabled.
CVBS
S-VIDEO
SDI
CVBS
S-VIDEO
SDI
Mark #1-
Disable 2-
259