Quantum Data 881 User Manual page 144

132 Chapter 4 Networking 882s
4. Press the Settings key. The Network Connection screen appears on the 882's display
as shown below.
Network Connection
Set TCP/IP
IP Address
206.135.215.168
If the IP Address configuration option is not visible, press the soft key adjacent to the
arrow symbol by SubnetMask until IP Address appears.
5. Change the IP address as follows:
a. Position the blinking cursor on the address digit you want to change. To do this,
press the soft key adjacent to the arrow by the address to move the cursor left or
right until it appears on the digit you want to change.
b. Adjust the value of the digit up or down by pressing the + or - keys. Repeat for each
IP address digit you want to change.
6. If necessary, change the subnet mask as follows:
a. If the SubnetMask configuration option is not visible, press the soft key adjacent to
the arrow symbol by IP Address until SubnetMask appears.
b. Position the blinking cursor on the subnet mask digit you want to change. To do
this, press the soft key adjacent to the arrow by the subnet mask to move the cursor
left or right until it appears on the digit you want to change.
c. Adjust the value of the digit up or down by pressing the + or - keys. Repeat for each
subnet mask digit you want to change.
Network Connection
Set TCP/IP
SubnetMask
000.000.000.000
7. To save the changes, press the Enter (Options) key. The following choices appear on
the 882's display:
Apply Settings?
Yes
To save the changes, choose the Yes item by pressing the adjacent soft key.
To exit without saving the changes, choose the No item.
To return to the Network Connection screen without saving the changes, choose the
Back item.
8. Power cycle the 882 to invoke the new IP address.
Back
No