Quantum Data 881 User Manual page 481

882 Video Test Instrument User Guide (Rev A.35)
12. Press the Tools key get back to the Reports menu.
13. Select HDCP to access the HDCP compliance test menu.
The following is displayed on the 882's LCD.
!CompRpt
14. Select !CompRpt to initiate the HDCP compliance test. Initiate each test individually.
The message "HDCP Compliance Test" is shown and then all the tests are shown in
sequence.
Alternatively, you can run the tests through the command line as shown below:
CPTX:CPTR 21
CPTX:CPTU
You can query the complete list of tests to choose from:
CPTX:GCTN?
You can query the currently selected test to run with:
CPTX:CPTU?
Refer to "To view the HDCP compliance
view the generated report.
15. Monitor the 882EA LCD for a set of prompts during the 3A-01, 3A-05 and 3B-01 tests.
a. When prompted with the screen shown below, examine the video on the display
connected to 882EA output 1. Press the appropriate button adjacent to the
indication (Yes! or No!) to continue.
Note: The prompt asks you if the video appearing on the connected display looks
good. "Looks good" means that there is a picture and an absence of excessive snow.
Does the video look
good?
!Yes
Note 2: The 1B-01 test should be run for both
settings of this parameter only if the Source Out
Only Repeater is set to yes. If Source Out Only
Repeater is set to no, this parameter is ignored
in the HDCP CTS 1.1 test.
Note 3: The 1B-01 test should be run for both
settings of this parameter for the HDCP CTS 1.2
test.
EditPCP
// Selects specific test (e.g. 3A_01) see table below
// Initiates the execution of the test
// Queries the list of tests supported
// Queries the selected test to run (see table)
report:" on page 605 for procedures on how to
No!
139