Testing Digital Computer (It) Fpds - Quantum Data 881 User Manual

Testing digital computer (IT) FPDs

HDMI interface testing
882 Video Test Instrument User Guide (Rev A.35)
This section describes how to test digital computer (IT) displays. You can test DVI on
digital computer displays using the 882C up to single link through the HDMI connector.
However you can test DVI digital computer displays up to full dual link on the 882D
through the dual link DVI connector. The procedures below describe how to test HDMI,
DVI or DisplayPort computer digital displays using the 882.
To set up the 882 to test a digital FPD:
1. Connect a single or dual link DVI cable between the DVI connector on the 882 and the
DVI connector on the display under test.
2. Determine the formats to test. See
instructions.
3. Determine the images to test. For digital flat panel displays, you typically want to select
images to test for pixel anomalies, persistence, photometry, and resolution-related
problems. For more information, see
"Image Reference."
To activate the HDMI-D interface on the output port:
1. Press the Interface key. A listing of signal interfaces appears on the 882's display as
shown below.
DVI-A
DVI-D
*
HDMI-D
HDMI-H
2. Choose the DVI-D item by pressing the adjacent soft key. The interface is activated and
the port outputs the currently selected image and format that is compatible with the
interface. An asterisk is shown beside the selected interface.
Alternatively, to activate the interface through the command line interface, enter the
following commands:
XVSI 2 // Selects the HDMI-D interface
ALLU // Applies the interface setting to the 882
To verify the test set-up:
1. Press the Source key to access the list of formats.
2. Choose a standard format (for example, DMT0660) by pressing the adjacent soft key.
Alternatively, you can load the format with the following command:
"Setting Source list of
"Selecting
CVBS
S-VIDEO
SDI
formats" on page 43 for
image" on page 47 or Appendix B,
51