Table of Contents
Advertisement
Resetting a generator
116
Chapter 3 Administrative Tasks
You can reset a generator to a known good condition.
Note: Resetting does not restore the generator to factory default condition. Thus, it should
not be used to restore proper operation of the generator.
Follow this procedure to reset a generator.
To reset the generator using the command line interface:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN. See
the
882" on page 30 or
2. Enter one of the following commands:
•
To reset the generator, enter:
*RST
•
To reset and calibrate the generator, enter:
*RST
SCAL
"Establishing a Telnet session with the
// Resets the generator
// Calibrates the generator
"Establishing a terminal session with
882" on page 33.
- Quick Links:
- Video Interfaces
Hide quick links:
Advertisement
Table of Contents
