Viewing And Modifying Format Parameters Via The Command Line - Quantum Data 881 User Manual

Viewing and modifying format parameters via the command line

882 Video Test Instrument User Guide (Rev A.35)
2. Enable and view image versions as follows:
a. Press the Options key. The following menu appears on the generator's display:
-More
-NoGamma
-Noise
b. Choose the More item by pressing the adjacent soft key until a + and Rendition
appears next to the item.
+More Rendition: 000
-NoGamma
-Noise
c. Press the + and - keys to advance through the image versions. Each version shows
the format parameters for a different format in the Source list.
Alternatively, to enable and view image versions using the command line interface,
enter the following commands:
ISUB 1 // Enables sub images
IVER 1 // Specifies the first image version
IMGU // Activates the image version
3. When you are finished, disable image versions by pressing the Options key and
choosing More until a - appears next to it.
Alternatively, to disable image versions using the command line interface, enter the
following command:
ISUB 0 // Disables sub images
Procedures for viewing and modifying the format parameters through the command line
are provided below.
To view and modify a format's options using the command line interface:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN. See
the 882" on page 30 or
2. Load the format whose parameters you want to view by entering the following
command:
FMTL format // Specify a valid format name
FMTU
Red+
Green+
Blue+
Red+
Green+
Blue+
"Establishing a Telnet session with the
"Establishing a terminal session with
882" on page 33.
157