Quantum Data 881 User Manual page 475

882 Video Test Instrument User Guide (Rev A.35)
center and trailing) with respect to the vertical sync pulse. You can set these
parameters either through the 882 front panel or the command line as follows:
CPTX:CRIP 0
CPTX:CRIP 1
CPTX:OESS 1
CPTX:OESS 2
CPTX:OESS 3
11. Press the Tools key get back to the Reports menu.
The 882 LCD will display the reports menu as shown below.
EDID
Misc
12. Select HDCP to access the HDCP compliance test menu.
The following is displayed on the 882's LCD.
!CompRpt
13. Select !CompRpt to initiate the HDCP compliance test. Initiate each test individually.
The message "HDCP Compliance Test" is shown and then all the tests are shown in
sequence.
Refer to "To view the HDCP compliance
view the generated report.
Alternatively to run a specific test you can use the command line as shown below:
CPTX:CPTR 17
CPTX:CPTU
You can query the complete list of tests to choose from:
CPTX:GCTN?
You can query the currently selected test to run with:
CPTX:CPTR?
// Specifies short read.
// Specifies combined read.
// Positions pulse at leading edge of vsync.
// Positions pulse at trailing edge of vsync.
// Positions pulse at center of vsync.
Packets
HDCP
EditPCP
report:" on page 605 for procedures on how to
// Selects specific test (e.g. 2C_01) see table below
// Initiates the execution of the test.
// Queries the list of tests supported.
// Queries the selected test to run (see table).
133