Running A Test Sequence Using The Command Line Interface - Quantum Data 881 User Manual

Running a test sequence using the command line interface

242 Chapter 8 Working with Test Sequences
3. Choose the sequence you want to run by pressing the adjacent soft key. The settings
for the selected sequence are shown on the generator's display:
+Red myseq
+Grn Auto:00001
+Blu DMT0660
Inv SMPTE133
Depending on the mode of the sequence, the sequence will either start automatically,
or you can press the + or - keys to move forward or backward manually through the
sequence steps.
The generator's display shows the format and image name for each step, the mode,
and the current step number. Additionally, the sync gate status and output status
appear on the right, and the color gate status appears on the left, as shown below.
+Red myseq
+Grn Step:00001
+Blu DMT0660
Inv SMPTE133
To stop a sequence or change the sequence mode:
1. With a sequence running, press the Options key. The mode menu appears as shown
below.
*Step
Wrap
Auto
Stop
2. Choose the desired mode by pressing the adjacent soft key.
Mode Description
Step Step and stop mode
Wrap Step and wrap mode
Auto Automatic mode.
Stop Stops the sequence
3. Press the Options key to return to the sequence settings.
To run a sequence using the command line interface:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN. See
the 882" on page 30 or
ACS
DCS
DSS*
Out+
ACS
DCS
DSS*
Out+
"Establishing a Telnet session with the
"Establishing a terminal session with
882" on page 33.