Viewing Generator Configuration Information - Quantum Data 881 User Manual

Viewing generator configuration information

882 Video Test Instrument User Guide (Rev A.35)
You can view information about a generator's configuration, including the firmware and
gateware revisions, installed options, board serial numbers, and so on. The procedure for
accessing this information depends on the type of information you want.
• For information about the main board and video board memory, use the front panel.
• For complete generator statistics, view the GenStats image.
• For firmware and gateware versions, use the command line interface.
This section describes the procedures for accomplishing these methods of accessing
generator configuration information.
To view generator configuration information using the front panel:
1. Press the Tools key. The Tools menu appears on the generator's display as shown
below.
System
Sequence
Probe
AFC
2. Choose the System item by pressing the adjacent soft key. The System menu appears
on the generator's display.
CalFactor
Network
Serial
BootFrom
3. Choose the About item by pressing the adjacent soft key. A following message
appears on the generator's display as shown below.
About the Phoenix
Press Settings
4. Press the Settings key. The main board information appears. Press the soft key
adjacent to the arrow by Serial Number to see other information about the main board.
About
Main Board
Serial Number
39298E000000
Reports
ImgShift
Analyzer
CEC
Host
About
Gpib
Init
->
->
117