Table of Contents
Advertisement
Resetting a generator
82
Chapter 2 Administrative Tasks
You can reset a generator to a known good condition.
Note: Resetting does not restore the generator to factory default condition. Thus, it should
not be used to restore proper operation of the generator.
Follow this procedure to reset a generator.
To reset the generator using the command line interface:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN. See
the
generator" on page 31 or
34.
2. Enter one of the following commands:
•
To reset the generator, enter:
*RST
•
To reset and calibrate the generator, enter:
*RST
// Resets the generator
SCAL
// Calibrates the generator
"Establishing a terminal session with
"Establishing a Telnet session with the
generator" on page
Advertisement
Table of Contents
Need help?
Do you have a question about the 881 and is the answer not in the manual?