Table 123: Multicast Filtering Commands - Edge-Core ECS4620-28P Cli Reference Manual

24
Multicast Filtering Commands
This switch uses IGMP (Internet Group Management Protocol) to check for any
attached hosts that want to receive a specific multicast service. It identifies the
ports containing hosts requesting a service and sends data out to those ports only.
It then propagates the service request up to any neighboring multicast switch/
router to ensure that it will continue to receive the multicast service.
Note that IGMP query can be enabled globally at Layer 2, or enabled for specific
VLAN interfaces at Layer 3. (Layer 2 query is disabled if Layer 3 query is enabled.)

Table 123: Multicast Filtering Commands

Command Group
IGMP Snooping
Static Multicast Routing
IGMP Filtering and
Throttling
MLD Snooping
MLD Filtering and
Throttling
MVR for IPv4
MVR for IPv6
IGMP (Layer 3)
IGMP Proxy Routing
MLD (Layer 3)
MLD Proxy Routing
Function
Configures multicast groups via IGMP snooping or static assignment,
sets the IGMP version, enables proxy reporting, displays current
snooping settings, and displays the multicast service and group
members
Configures static multicast router ports which forward all inbound
multicast traffic to the attached VLANs
Configures IGMP filtering and throttling
Configures multicast snooping for IPv6
Configures MLD filtering and throttling for IPv6.
Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving security
and data isolation for normal traffic
Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving security
and data isolation for normal traffic
Configures the IGMP protocol used with multicast routing in IPv4
networks
Collects and sends multicast group membership information onto the
upstream interface based on IGMP messages monitored on
downstream interfaces, and forwards multicast traffic based on that
information
Configures the MLD protocol used with multicast routing in IPv6
networks
Collects and sends multicast group membership information onto the
upstream interface based on MLD messages monitored on
downstream interfaces, and forwards multicast traffic based on that
information
– 665 –