Editing Z-Wave Device Names - Honeywell VISTA User Manual

iii. At the VAM:
a) To verify activation, Click the Back button and wait 30
seconds. Click the Refresh button; the new device is displayed.
The screen displays a series of messages:
D. Z-Wave Water Valves
Have a professional plum ber install the Z-Wave water valve The
device should be mounted in the final location and tested before
adding it to the system.
NOTES:
• Honeywell is not responsible for property damages due to
improper installation of the water valve.
i. Perform steps 1 & 2 above.
ii.. At the Z-Wave water valve press the function key to enroll
iii. At the VAM:
a) To verify activation, Click the Back button and wait 30
seconds. Click the Refresh button; the new device is displayed.
The screen displays a series of messages:

Editing Z-Wave Device Names

You can change the name of a device by using the Edit Name button:
1. Go to the Z-Wave Management screen (Automation > Z-Wave Setup).
2. Highlight the device name and click the Edit Name button.
3. Enter a new name.
4. Click OK.
5. To display a different icon select the icon from the list below (NOTE: this
only applies to binary and multilevel switches):
Light Bulb Light Switch
Water Faucet Strobe
"Please press function key on device"
"Adding Controller Unit"
"Adding Slave Unit"
"Device added successfully"
"Please press function key on device"
"Adding Slave Unit"
"Device added successfully"
Garage Door
Window
– 15 –
Pool
Sprinkler
Siren/Sounder Fan