Configuring Univerge Um8500 For The Integration - NEC UNIVERGE UM8500 Integration Manual

Configuring
UNIVERGE
UM8500 for the
integration
UNIVERGE UM8500 I
324
After ensuring that the UM8500 server is ready for the integration by completing
all appropriate tasks in the Installation Guide, perform the following procedure to
confirm that the integration is enabled.
To configure the UM8500 server for integration
1 Start > All Programs > UNIVERGE UM8500 > Key Dump
Click
Integration
2
Verify the
Start > All Programs > UNIVERGE UM8500 > Edit Switch
3
Click
4
If prompted for logon credentials, type the administrator extension and
OK
password, then click
On a new install the logon credentials are:
Extension = 99995
■
Password = 12345
■
5
Confirm that the settings match those in the following table. If the settings are
incorrect, integration features may not be enabled.
Phone system setting
Parameter
Manufacturer
Model
Specific Version or Country ALL
Integrations
6
Stop UNIVERGE UM8500 if it is running.
7
Run VOIPAdmin.exe from Commserver\Utilities folder.
The VoipAdmin Tool appears.
IP Protocol
8
In the field, select
9
Type the <name> or <IP address> of phone switch in the
IP Address
field.
10
The server name can be left blank.
11
Type the <IP address> of the SIP proxy in the
field.
Peer-to-Peer
12
Select the
Peer-to-Peer.
Select only if the port authentication does not required a
●
password.
Use Authentication.
●
authenticated username and password.
Select neither.
●
authentication requires a password.
Manage Ports
13
Under
Add
a
Click to add a new port.
b
Type the information for each port.
Extension
Type the
as required.
OK
14
Click to save the changes and then close the VoipAdmin Tool.
15
Start UNIVERGE UM8500.
16
In your Internet browser, go to UM8500 Administrator
(http:// <server name>
G
NTEGRATION UIDE
Standard SIP
setting is
.
Required settings
Defaults
Default Parameters
Standard SIP
Standard SIP
.
User Authentication
or
Select only if the port authentication requires an
Leave both selections unchecked if the port
,
of each port as long as
/saweb).
.
Multiple Integrations
or
.
PBX Name
SIP Proxy IP Address
check box as follows:
Password Authname
and
.
or