Configuring The Sv8100 - NEC univerge sv8100 Installation Manual

Configuring the SV8100

The SV8100 should have an IP address assigned to the CCPU or IPLA card that is connected
st
to the network. A TCP Port has to be assigned to the 1 Party CTI driver to connect to, the
recommended port is 8282.
Assign the port in Wizards / Advanced Items / CTI / CTI LAN Port Setup (PRG 10-20 Dev9.)
st
Set the 1 Party CTI TCP Port to 8282.
st
A license is required for each 1 Party CTI client that will be concurrently used (BE107580).
st
You can use 128 1 party CTI clients when the 60 day license is running.
If using Aspire Phones (Model C) programming command 15-02-53 must be set to a 1.
This changes the operation of the phone to a DT3xx/7xx