NEC UNIVERGE UM8500 Integration Manual page 166

UNIVERGE UM8500 I
156
To program the IP-VPS ports
1
Make sure that the NEAX 2400 system has enough IP licenses using the DPTR
command.
2
Configure the voice messaging ports as IP-VPS extensions using AISTL
command, KIND=IP VPS, TEC = 26.
3
Assign them successive VPS channels, starting with IP VPS CH= 0.
4
Write down the VPS ID value of the voice messaging ports, so the value is
available when the UNIVERGE UM8500 installation wizard asks for it.
CAUTION
All voice messaging ports must have the same value assigned for
●
VPS ID.
Make sure the phone system is using the Protected Login Mode for
●
the voice mail IP ports registration and set the password of each port
to be the same with the port extension.
5
Specify a Service Feature Restriction Class (SFC) for the voice messaging
ports, see the ASFC command. It is recommended that all voice messaging
ports be placed in their own SFC. The following Service Feature Indexes (SFIs)
are needed in the SFC:
SFI Service feature
10 Call hold
103 Assignment of no answer timer for blind transfer
to station or blind transfer to attendant
104 Blind transfer
6
Assign all of the voice messaging ports to a Uniform Call Distribution (UCD)
group using ASHU command.
NOTE
If the phone system that hosts the voice messaging ports
extensions is part of a NEC Fusion network and those ports need
to be accessible from the other Fusion nodes, then the UCD must
be configured to contain the logical numbers corresponding with
the ports extensions, see the ALGSN, ASHUN commands.
CAUTION
Do not use a phantom single line extension for the UCD pilot
number.
7
Complete programming the phone system. See
the phone system" on page
To program the IP Terminal ports
1
Make sure that the NEAX 2400 system has enough IP licenses using the DPTR
command.
2
Configure the voice messaging ports as IP Terminal extensions using the
AISTL command, KIND=IP DTERM, TEC = 12.
3
Make sure the phone system is using the Protected Login Mode for the voice
mail IP ports registration and set the password of each port to be the same
with the port extension.
G
NTEGRATION UIDE
"To complete programming
157.