Configuring Univerge Um8500 For The Integration; Configuring Univerge Um8500 Ports - NEC UNIVERGE UM8500 Integration Manual

Configuring
UNIVERGE
UM8500 for the
integration
After ensuring that the voice mail server is ready for the integration by completing
all appropriate tasks in the Installation Guide, perform the following procedure to
confirm that the integration is enabled.
To confirm that the integration is enabled
1 Start > All Programs > UNIVERGE UM8500 > Edit Switch
Click
2
If prompted for logon credentials, type the administrator extension and
OK
password, then click
On a new install the logon credentials are:
Extension = 99995
Password = 12345
3
Confirm that the settings match those in the following tables.
Phone system settings for integrations with analog ports
Parameter
Manufacturer
Model
Switch PBX software version 4203 and later with analog
Integration
Phone system settings for integrations with digital ports
Parameter
Manufacturer
Integration
Switch PBX software version 4203 and later with digital boards
Integration
Phone system settings with T1 ports
Parameter
Manufacturer
Integration
Switch PBX software version 4203 and later with T1 boards and
Integration
Phone system settings with IP Terminal or IP-VPS ports
Parameter
Manufacturer
Integration
Switch PBX software version Software release 16 or later with
Integration
4
If the settings are incorrect, select the correct settings and click
Voice Mail Now
.

Configuring UNIVERGE UM8500 ports

Configure the UM8500 voice ports. The procedure used depends on the port type
the system is using.
For IP-VPS or IP Terminal ports, see
●
ports" on page 160.
NEC NEAX 2400
.
Required setting
NEC
NEAX2400 IMS
boards and MCI
Serial
Required setting
NEC
NEAX2400 IMS
and MCI
Serial
Required setting
NEC
NEAX2400 IMS
MCI
Serial
Required setting
NEC
NEAX2400 IMS
IP ports
Serial
"To configure IP-VPS or IP Terminal
WITH SERIAL
.
Update
MCI
159