Integration Overview; Integration Steps; Requirements - NEC UNIVERGE UM8500 Integration Manual

Integration
overview
UNIVERGE UM8500 I
180
Use this section of the Integration Guide with the Installation Guide.

Integration steps

Follow these steps to set up this integration.
Review the system and equipment requirements.
1
Verify that all phone system and messaging system server requirements have
been met. See "Requirements," below.
If the system uses T1 voice messaging ports, set up the
2
digital trunk interface board.
See "Setting up the trunk
Program the phone system and extensions.
3
See "Programming the phone
Configure UNIVERGE UM8500 for the integration.
4
See "Configuring the UNIVERGE UM8500 for

Requirements

The steps to set up the NEC NEAX 2400 or SV7000 Message Center Interface (MCI)
integration with a LAN interface require the following:
Phone System
A NEAX 2400 IMX or SV7000 (model T10 or T20) phone system with LAN MCI.
●
A network connection to the UNIVERGE UM8500 server.
●
One or more of the following station ports set up as voice messaging ports:
●
Port type Description
Analog One analog station port for each voice messaging
port.
T1 One digital line interface card for each group of
24 voice messaging ports.
Digital One digital station port for each voice messaging
port.
IP-VPS One IP-VPS port for each voice messaging port.
IP Terminal One IP Terminal port for each voice messaging
port.
UNIVERGE UM8500 server
A network connection with the phone system.
●
The Dialogic voice boards installed; see the Installation Guide for installation
●
details.
NOTE
For the latest information on supported voice boards for UM8500,
●
contact a sales representative.
No voice boards are required if IP-VPS or IP Terminal ports are used.
●
UNIVERGE UM8500 installed and ready for the integration as described in
●
the Installation Guide.
A system key that enables the integration and the appropriate number of
●
voice messaging ports.
G
NTEGRATION UIDE
board" on page 182.
system" on page 184.
integration" on page 188.