NEC UNIVERGE UM8500 Integration Manual page 178

UNIVERGE UM8500 I
168
Cmd Sys Index
RSVI SVI 1650
SVI 1755
SVI 1760
2
Use the following table to configure the OAI pilot number. The OAI pilot
number is used to dispatch calls to the voice mail ports, similar to the voice
mail pilot number.
NOTE
This setting is not required for the OAI UCD-LAN/Serial MCI
integration.
Command
(Description)
AMNO (Assignment of
Monitored Number)
3
If using the OAI UCD-LAN/Serial MCI integration, use the following table to
configure the Message Center Interface (MCI). If using an OAI pure
integration, skip this step.
NOTES
MCI cannot be active on both serial and LAN interfaces at the same
●
time. If possible, enable MCI over LAN for the best system
performance.
The same settings must be enabled in the OAI Server software.
●
Do not adjust MCI settings if using an OAI pure integration.
●
Cmd Sys Index
ASYDL 1 833
1 833
1 834
1 834
ASYD 1 246
1 400
G
NTEGRATION UIDE
Bit Value Sample
1 1 Call Fwd status for answer
SMFN
1 1 Call Fwd reason
enhancement (over CCIS)
1 1 Release SMFN
enhancement
Parameter
A/G
TN
MNO
NMI
MFC
UCD
Bit Value Sample Description
0 1 03 MCI type:
0 = IOC (Input-Output
Card) serial
1 = LAN
1 1 03 MCI text format:
0 = ICS
1 = IMX
0 1 03 MCI 0 LAN Interface in
service:
0 = No
1 = Yes
1 1 03 MCI 1 LAN Interface in
service:
0 = No
1 = Yes
3 1 08 MCI Expansion:
0 = Normal
1 = Expanded
2 1 04 Expanded MCI with ANI
Data:
0 = No
1 = Yes
Description
Value
A
1
299
1
0
0