Table of Contents
Advertisement
UNIVERGE UM8500 I
160
For analog, T1, or digital ports, see
●
on page
160.
To configure IP-VPS or IP Terminal ports
1
Stop the UNIVERGE UM8500.
2
Run VOIPAdmin.exe from Commserver\Utilities folder.
The VoipAdmin Tool appears.
3
Enter the PBX IP address.
4
Set the general functionality for the ports (VPS or Terminal.)
If the system has VPS ports, enter the
5
Under Manage ports, click
Extension
Enter the
If the system has VPS ports, enter the VPS Channel for each port.
6
If the system uses one or more IP PADs, under Manage Gateways, click
IP Address
Enter the
OK
7
Click
to save the changes and then close VOIPAdmin.
8
Restart UNIVERGE UM8500.
To configure Analog, T1 or Digital ports
1
Make sure that UNIVERGE UM8500 is running.
2
In Internet Explorer, go to the UM8500 Administrator
http://<server name>/saweb
System > Ports
3
Go to
must be introduced as station numbers, not logical numbers and without the
office codes, if they have any. Save the changes.
G
NTEGRATION
UIDE
"To configure Analog, T1 or Digital
VPS Number
Add
to add a new port.
Password
and
for each port.
Has DSP
and set the
to 0 for each gateway.
. Type the extension of each port. These extensions
ports"
.
Add
.
Advertisement
Chapters
Table of Contents
Troubleshooting
