NEC UNIVERGE UM8500 Integration Manual page 58

UNIVERGE UM8500 I
48
To modify voice port settings
System Ports
1
Go to >
2 Port Assignments
In the
to each phone system. The port range for the traditional phone system is port
1 through x , where x is the number of ports on the installed voice board. The
port range for CallManager is x + 1 through y , where y is the number of TAPI
ports installed on the server or the number of licensed voice ports on the
system key, whichever is lower.
3
Type an extension for each port.
4
Specify other settings as appropriate. For each phone system, verify that an
appropriate number of ports are used to answer calls and to dial out for
message waiting indicators (MWIs), message notifications, and Media Master
recordings by phone.
Save
5
Click .
CAUTION
The port range for each phone system must be set as specified in
step 2 above. If there is a port range mismatch, UM8500 is unable
to answer incoming calls and dial out.
To select which phone system subscribers and call
handlers use
For existing subscriber templates, subscriber accounts, and call handlers,
UM8500 defaults to the traditional phone system. During the initial setup of the
dual-switch integration, you will modify only those pages that will use
CallManager. Note that changes made to subscriber templates do not affect
existing subscribers.
1
As appropriate, go to:
Subscribers Subscriber Template
>
Subscribers Subscribers
>
Call Management
>
Switch
2
In the list, select the phone system.
3
Adjust other settings as appropriate. See the System Management Help for
more information.
CAUTION
If the Switch setting on the subscriber's or call handler's Profile
page does not match the phone system actually used by a
subscriber or call handler, UM8500 is not able to transfer calls to
or from the subscriber or call handler. Additionally, UM8500 is
unable to turn the subscriber's MWIs on or off and unable to reach
the subscriber's extension for Media Master recording by phone.
G
NTEGRATION UIDE
.
section, indicate the range of ports to be assigned
Profile
>
Profile
>
Call Handlers Profile
>