Integration Overview; Integration Steps; Requirements - NEC UNIVERGE UM8500 Integration Manual

Integration
overview
UNIVERGE UM8500 I
144
Use this section of the Integration Guide with the Installation Guide.

Integration steps

Follow these steps to set up this integration.
Review the system and equipment requirements.
1
Verify that all equipment, phone system and messaging system server
requirements have been met. See "Requirements," below.
Program the phone system and extensions.
2
See "Programming the phone
Configure UNIVERGE UM8500 for the integration.
3
See "Configuring UNIVERGE UM8500 for the

Requirements

The steps to set up the NEC NEAX 2400 IP Protims integration require the
following:
Equipment
®
All Dterm IP phones that will be used with UNIVERGE UM8500 must have
●
software version 1.2 or newer.
NEAX 2400 phone system
A NEAX 2400 IMX software version 16 or newer or SV7000, model T10 or T20,
●
installed and ready for the integration as described in the phone system
documentation.
Password encryption type for IP extensions is MD5, see command ASYDL,
●
index 848, b7=0.
Fully functional IP PAD cards with VCTI sub-boards.
●
NOTE
IP PAD cards provide interface function between IP telephony,
terminals or other devices on LAN, and non-IP telephony,
conventional networks such as PSTN, ISDN, and private networks.
If the telephony network is 100% IP, the IP PAD cards are not
mandatory.
UNIVERGE UM8500 server
If the G729 codec is used, the Sipro Lab G729 codec driver must be installed in
●
the voice mail server. The installation file for this driver is named
sl_g729a_setup.exe and can be found in the Voice Mail\Utilities folder on the
Installation disc.
A system key that enables the integration and the appropriate number of
●
voice messaging ports.
G
NTEGRATION UIDE
system" on page 146.
integration" on page 147.