Programming The Phone System - NEC UNIVERGE UM8500 Integration Manual

Programming
the phone
system
UNIVERGE UM8500 I
146
If programming options other than those described in the following procedures
are used, the integration's performance might be affected.
NOTE
The following procedures are written on the assumption that you
will use a Maintenance Administration Terminal (MAT) to program
the phone system.
To program the IP voice messaging ports in the phone
system
1
Make sure that the NEAX 2400 phone system has licenses for using IP
extensions by using the DPTR command.
2
Configure the voice messaging ports as IP-VPS extensions by using the AISTL
command to set "KIND = IP VPS" and "TEC = 26."
Assign the ports successive VPS channels, starting with "IP VPS CH = 0."
3
Write down the VPS ID value of the voice messaging ports, for use during the
UM8500 installation. Enter the value when the UNIVERGE UM8500
installation wizard asks for this value.
CAUTION
All voice messaging ports must have the same value assigned for
VPS ID.
4
Write down the MWI analog codes that the NEAX 2400 phone system uses for
turning the phones lamps on and off. These codes are needed when
configuring UM8500 to work with the integration.
NOTE
The NEAX 2400 phone system may not have any settings made to
use codes for MWI analog operations. If this is the case, use the
ANPD and ASPA commands to set "SRV=SSCA" and "SIDA=54 /
55."
5
Specify a Service Feature Restriction Class (SFC) for the voice messaging ports
by using the ASFC command. It is recommended that all of the voice
messaging ports be placed in their own SFC. The following Service Feature
Indexes (SFIs) are needed in the SFC:
SFI Service feature
10 Call hold
103 Assignment of no answer timer for blind transfer
to station or blind transfer to attendant
104 Blind transfer
6
Assign all of the voice messaging ports to a Uniform Call Distribution (UCD)
group using the ASHU command.
7
Set the same location ID for all voice messaging ports and set either or both of
the codecs G711, U-Law or A-Law, and G729A with payload size equal to 40
milliseconds for that location ID using the commands ALOCL and AIVCL.
NOTE
To associate the voice messaging ports with a specific location,
add the IP address of the messaging system server to that
location.
G
NTEGRATION UIDE