NEC UNIVERGE UM8500 Integration Manual page 132

UNIVERGE UM8500 I
122
Command
08>443:1-0
4000>0>10
4001>0>1
4002>0>1
4004>0>0
4008>0>4
To set the OAI configuration
Verify the following configurations and settings.
Verify the
1
AP01 card (OAI) is plugged in to LT09/AP09.
2
Verify the CC01 card (LAN) is plugged in to LT10/AP10.
3
Verify the AP01 & CC01 cards are connected with NR-553876-001 cable.
4
Verify the AP01 chipset = 2931.
5
Verify the CC01 chipset = 2932 (!).
6
Verify the IP Address is set per the phone system configuration, for example
172.16.19.60.
7
Verify the Subnet mask is set per the phone system configuration, for example
255.255.255.0.
8
Verify the OAI pilot is set per the phone system configuration, for example
299.
9
Verify the monitored extensions, voice ports, are set per the phone system
configuration, for example 209-212.
10
Verify the monitored DTerm Function Keys on extension 201 are set per the
phone system configuration, Example 09-12 (function codes F1032-F1035;
Terminal Mode Facility codes 192-195).
11
Verify the OAI monitoring slots 1024-1039, in the OAI server configuration
according to the OAI XML template chosen, are set to:
Command
B-load, C-load
F83>0>...
Reset CP14 (SW1)
F83>2>0
050>
AP01 sense wheel on 04
Reset CP14 (SW1)
050>04:07
D79>00>172
D79>01>016
D79>02>019
D79>03>060
D79>04>255
D79>05>255
D79>06>255
D79>07>000
Reset CP14 (SW1)
NOTE: Do not run the following command if the OAI UCD -
Serial MCI integration method is used.
G
NTEGRATION UIDE
Description
Set the type of VMS integration: MCI (0) instead of
DTMF (1) (!)
Function = MCI
Data length = 8 bit
Parity check = Ineffective
Stop bit = 1
Data speed = 9600 bps
Description
Reset PBX memory
IVR # (need to restart system to take effect)
Update changes
0 = IVR code is good
Hardware initialization for AP01
Set the OAI slot 4 (hardware)
Update changes
Set the OAI slot 4 (software)
Assign IP address: 172.16.19.60
Assign subnet mask: 255.255.255.0
Update changes