NEC UNIVERGE UM8500 Integration Manual page 219

Leave all other parameters not listed above at their default values.
7
In the navigation pane of the configuration file, expand VMSystem1 node.
Set the following parameters to configure the VMSystem1 node:
Host.
Enter the IP address of the monitored UNIVERGE UM8500 server. This
will be the same IP address entered previously in the configuration ini file.
The default value is just an example.
PortRange.
Enter the port or range of ports for the PBX tenant hosting the
voice mail ports. Ports can be set by entering a single port number, for
example ; a range of numbers, for example
xxxx
combination or both, for example
an example.
Tenant.
Enter the PBX tenant number where the voice mail ports are set.
The default value is 1.
Leave all other parameters not listed above at their default values.
File > Save
8
Click to save the XML configuration file.
9
Install the OAI service and test the integration.
See "Installing and starting the OAI
NEC UNIVERGE SV7000
xxxx-xxxx
. The default ports are just
xxxx-xxxx,x
service" on page 210.
OAI
WITH
; or a
209