NEC UNIVERGE UM8500 Integration Manual page 41

Field
Device type
Device name
Description
Device pool
Location
How many lines do you want to
assign to the device?
Directory number
Display
Forward all
Forward busy
Forward no answer
5
After the values are entered, the Device Wizard–Confirmation screen appears.
Finish
Click . The Device Wizard–Finish screen appears.
6
On the Device Wizard–Finish screen, click
Continue
7
Click to confirm that the system should reset the TAPI port now.
8
After receiving confirmation that the device was reset, click
9
Repeat steps 4 through
10
On the Cisco CallManager Administration toolbar, click
Cisco IP Phone
then click
been added, as well as any new IP phones and other devices.
11
Click the name of the added TAPI line. A Device Information screen appears,
showing the values entered for that line. Use the Device Information screen to
correct any errors.
12
Write down the number of TAPI lines that were added and the assigned TAPI
prefix name. This information will be needed when the Cisco TAPI service
provider (TSP) telephony driver is configured on the messaging system
server.
13
Close the Cisco CallManager Administration program, then go to the
appropriate procedure:
If the site is using a version of CallManager at least 3.05 but prior to 3.2,
■
go to "To add uOne ports to CallManager version
If the site is using CallManager 3.2 or later, go to
■
to CallManager version 3.2 and
Value
Click TAPI port.
Type a name for the TAPI port, for example,
Optional. Type a brief description of the purpose, for example,
Customer Service
Click Default pool.
Click Hub.
Type .
1
Type the extension that will be connected to UM8500.
Type the number that appears in a phone display when an external call
arrives on this line.
Leave this field blank.
CAUTION!
Type the extension of the next TAPI port in sequence. If this extension is
the last TAPI port, then type the extension of the first TAPI port.
If the directory number for this TAPI port is busy, calls are forwarded to
the extension shown in this field.
Type the extension of the next TAPI port in sequence. If this extension is
the last TAPI port, then type the extension of the first TAPI port.
If the directory number for this TAPI port is not answered, calls are
forwarded to the extension shown in this field.
The Forward no answer setting is used when the port is disabled or out
of service.
OK, reset now
8 for each TAPI line.
. The Phone list shows the TAPI lines that have
later" on page 34.
tapi_01
.
Do not set a value for this field. If information
appears in this field, the messaging system might
operate improperly.
C C M
ISCO ALL ANAGER
.
Continue
.
Configuration
,
3.05" on page 32.
"To add voice mail ports
.
31