Configuring The Oai Integration Server - NEC UNIVERGE UM8500 Integration Manual

Configuring the
OAI
Integration
Server
Modify the configuration file to set how calls are handled in the integration.
To configure the OAI Integration Server
1
From the Windows taskbar, click
OAI Integration AVOAITray
>
The OAIS icon appears in the notification area of the system tray.
2
Right-click the OAIS icon, then click
The OAIGear page appears.
WARNING!
If an error message appears indicating the service is not installed,
close the error dialog box and continue with this procedure. The
AV OAI Integration service will automatically install after the
procedure is completed.
3
On the OAIGear toolbar, click the
The configuration file for the OAIS parameters appears in an XML editor.
4
In the navigation pane of the configuration file, expand CallPilot1 to
configure the CallPilot.
In the navigation pane, under the CallPilot object, there are some predefined
values for all parameters. Depending on the template chosen, set the
following values:
PBX-IP:
Enter the IP address of the phone system, or if the phone system is
connected to the same LAN as the UM8500 server through a different
network interface card, enter the IP address of the network interface card.
The default value is only an example.
PBX-Port:
Enter the OAI monitoring port of the phone system. Depending
on the template previously chosen, the default value will be 1024 for a NEC
2000 IVS or IVS2 or 60030 for a NEC IPS 2000 phone system. Modify the
default value only if you know that the phone system is set to a different
value.
Tenant:
PBX Tenant where the OAI pilot or AMNO number is defined
physically. If the integration is MCI based, this will be the tenant number
where the UCD is configured. This value should match the one in the phone
system configuration. The default value is 1.
Extension:
If one of the templates that enables an OAI UCD - MCI Serial
integration, such as NEC IPS 2000 - OAI-UCD - MCI or NEC 2000 IVS - OAI-
UCD - MCI, was selected, this field can be left blank according to the
predefined settings.
If one of the templates that enables an OAI pure integration, such as NEC
2000 IVS - OAI Pure - No CCIS or NEC IPS 2000 - OAI Pure - No CCIS, was
selected, then enter the CallPilot's OAI monitored extension. If the extension
is a virtual number associated with the auto attendant, this will be the
monitored number that is called to access the voice messaging system. The
default value is just an example.
Leave all other parameters on their default values.
5
If the system is using the Live Record feature, in the navigation pane of the
configuration file, expand the LiveRecord node, and set the following
parameters:
NOTE
Skip this step if the system is not using the Live Record feature.
Start All Programs
>
.
Advanced
.
Configuration File
NEC NEAX 2000 OAI
WITH
Active Voice
> >
icon.
131