NEC UNIVERGE UM8500 Integration Manual page 57

Hide thumbs Also See for UNIVERGE UM8500:
Table of Contents

Advertisement

Select the phone system that subscribers and call handlers
4
use.
See
"To select which phone system subscribers and call handlers
page
48.
Select the phone system that UM8500 uses when dialing out
5
to send message notifications.
See
"To select which phone system UNIVERGE UM8500 uses for message
notification and
MWI"
CAUTION
If you need to add or remove voice boards or uninstall the voice
board software after the dual-switch integration is set up, you
must also remove the Cisco TAPI service provider. Do not reinstall
the Cisco TAPI service provider until after the voice boards have
been set up or the voice board software is reinstalled. See
"
Changing the number of uOne ports
information.
To specify phone system settings for the traditional
phone system
System
Switch
1
Go to
>
system selected during the UM8500 setup program are displayed.
Access Code
2
In the
to transfer calls to Cisco CallManager from the traditional phone system.
3
Adjust other settings as appropriate. See the System Management Help for
more information about the other settings on the Switch page.
Save
4
Click
, then click
To specify phone system settings for Cisco CallManager
System
Switch
1
Go to
>
Set Active Switch Type
2
In the
following table:
Phone system settings
Parameter
Manufacturer
Model
Switch PBX software version
Integration
Set As Active
3
Click
, then click
Access Code
4
In the
to transfer calls to the traditional phone system from CallManager.
5
Specify the settings in
as needed. See the System Management Help.
Save
6
Click
, then click
on page
49.
"
on page 43
Switch
>
. The settings for the traditional phone
field, type the trunk access code that UM8500 must dial
OK
in the Warning dialog box.
IP Switch
>
.
section, enter values as shown in the
Required setting
Cisco
CallManager
3.0.5 or later
Multiple
OK
in the Warning dialog box.
field, type the trunk access code that UM8500 must dial
Resynch All Message Waiting Indicators
OK
in the Warning dialog box.
C
C
M
ISCO
ALL
use"
on
, for more
section
ANAGER
47

Advertisement

Table of Contents
loading

Table of Contents