Table of Contents
Advertisement
Parity:
Enter the parity used by the serial (RS-232/MCI) communication
with the phone system. Accepted values are
ODD. The default value is N.
StopBits:
Enter the stop bits used by the serial (RS-232/MCI)
communication with the phone system. Accepted values are
specially defined phone system setting. The default value is 1.
Leave all other parameters not listed above at their default values.
7
In the navigation pane of the configuration file, expand VMSystem1 node.
Set the following parameters to configure the VMSystem1 node:
Host:
Enter the IP address of the monitored UM8500 server. This will be the
same IP address entered previously in the configuration ini file. The default
value is just an IP example.
PortRange:
Enter the port or range of ports for the phone system tenant
hosting the voice mail ports. Ports can be set by entering a single port
number, for example
xxxx
or a combination or both, for example
just an example.
Tenant:
Enter the phone system tenant number where the voice mail ports
are set. The default value is 1.
Leave all other parameters not listed above at their default values.
File > Save
8
Click
to save the XML configuration file.
9
Install the OAI service and test the integration. See
OAI
service"
on page
134.
N
for NONE,
; a range of numbers, for example
xxxx-xxxx,x
"Installing and starting the
NEC NEAX 2000
OAI
WITH
E
O
for EVEN, or
for
1
1.5
2,
,
,
or the
xxxx-xxxx
;
. The default ports are
133
Advertisement
Chapters
Table of Contents
Troubleshooting
