Changing The Number Of Uone Ports - NEC UNIVERGE UM8500 Integration Manual

Changing the
number of
uOne ports
To change the number of uOne ports after the CallManager is installed and set up,
perform the following procedures.
To change the number of uOne ports in CallManager
1
On the CallManager server, use the Cisco CallManager Administration
program to add or remove uOne lines, as appropriate.
For information on adding uOne ports, see
CallManager version 3.05" on page 32. For information on removing uOne
ports, see the Cisco CallManager Administration online Help.
2
Shut down and restart the CallManager server.
3
Continue with the next procedure.
To change the number of uOne ports for the Cisco Unity-
CM TAPI Service Provider
1
On the messaging system server, log on to Windows as an administrator.
2
On the Windows taskbar click
3 Phone and Modem Options
Double-click
Options dialog box appears.
Advanced
4
Click the tab.
Cisco Unity-CM TSP
5
Click
dialog box appears.
6
Select the IP address of the CallManager server on which uOne ports were
added.
Settings
7
Click . The Cisco Unity-CM TSP Settings dialog box appears.
Number of voice ports
8
Change the
configured in the Cisco CallManager Administration program.
9 OK
Click to close the Cisco Unity-CM TSP Settings dialog box.
Close
10
Click to close the Phone and Modem Options dialog box.
11
Shut down and restart the messaging system server.
"To add uOne ports to
Start> Control Panel
. The Phone and Modem
Configure
, then click . The Cisco Unity-CM TSP
to the number of uOne ports currently
C C M
ISCO ALL ANAGER
.
43