Integration Overview; Integration Steps; Requirements - NEC UNIVERGE UM8500 Integration Manual

Integration
overview
UNIVERGE UM8500 I
150
Use this section of the Integration Guide with the Installation Guide.

Integration steps

Follow these steps to set up this integration.
Review the system and equipment requirements.
1
Verify that all phone system and messaging system server requirements have
been met. See "Requirements," below.
If the system uses T1 voice messaging ports, set up the
2
digital trunk interface board.
See "Setting up the trunk
Program the phone system and extensions.
3
See "Programming the phone
Configure UNIVERGE UM8500 for the integration.
4
See "Configuring UNIVERGE UM8500 for the
Test the phone extensions.
5
Test the phone extensions that are set up for the integration. See Appendix B,
"Testing the extensions" on page 338.
Run the Learn Tones utility.
6
Run the Learn Tones utility to teach the messaging system the tones
associated with the phone system. See Appendix C,
tones" on page 340.

Requirements

The steps to set up the NEC NEAX
integration with a serial interface require the following:
Phone system
One of the following NEAX 2400 phone systems with MCI:
●
Port system Software version
IMX All software version
IMG and SIM 5200 or later
MMG and UMG 4200 version 5 or later
T1 One digital trunk interface board (card
number PA-24DTR/DLI) with program version
SP3298 3A 001 or later for each group of 24
voice messaging ports.
NOTE
IMG and SIM phone systems might require upgrading to a high-
density system to support MCI.
One IOC serial port for the MCI data link connected to a serial port, COM1 is
●
the default, on the voice mail server with a PH-68 two-port cable and an RS-
232C CA-1 cable.
MCI feature II installed according to NEC document ETI No. 121A (October
●
1998) and the NEAX 2400 IMX Message Center Interface (MCI) Specifications,
ND-70428(E) Issue 1 (January 1999), NEC #200892.
One or more of the following station ports set up as voice messaging ports:
●
Port type Description
Analog One analog station port for each voice messaging port.
T1 One digital trunk interface board (card number PA-24DTR/
DLI) with program version SP3298 3A 001 or later for
each group of 24 voice messaging ports.
G
NTEGRATION UIDE
board" on page 153.
system" on page 155.
integration"
®
2400 Message Center Interface (MCI)
on page 159.
"Learning phone system