Table of Contents
Advertisement
CM 170>3900>3901
CM 170>3901>3902CM 170>3902>3903
CM 170>3903>3904CM 170>3904>3905
CM 170>3905>3906CM 170>3906>3907
CM 170>3907>3999
j
CM 171>3999>1
k
Assign Pilot and ports to a UCD group number:
CM 172>3999>00
CM 172>3900>00
CM 172>3901>00
CM 172>3902>00
CM 172>3903>00
CM 172>3904>00
CM 172>3905>00
CM 172>3906>00
CM 172>3907>00
l
CM 5115>01>3999
number
m
CM 5110>01>3999
n
CM 5118>01>3999
o
CM 200>*9>A040
p
CM 200>#9>A041
q
CM 200>*4>A006
needed (example of code)
r
xxxx
CM 9000>
,01>
xxxx is the IP extension numbers (3901-3907 in this example)
s
Enable VM Softkeys:
CM 1337>3900>0
CM 1337>3901>0
CM 1337>3902>0
CM 1337>3903>0
CM 1337>3904>0
CM 1337>3905>0
CM 1337>3906>0
CM 1337>3907>0
t
Enable Softkey call screening system wide
CM 08>715>0
3
Make sure that the following service features are enabled in the phone
system:
Call hold
■
Assignment of no answer timer for blind transfer to station or blind
■
transfer attendant
Blind transfer
■
4
Set the same location ID for all voice messaging ports and set either or both of
the codecs G711, U-Law or A-Law, and G729A with any payload your system
may need (10, 20, 30, or 40).
NEC UNIVERGE SV8300
Point each port to the next.
Finally point last port back to pilot.
Assigns Pilot number as a UCD Pilot
Assigns the UCD Pilot number to the tenant
Allows MWI lamp ON (example of code)
Allows MWI lamp OFF (example of code)
Allows executive override for Live Record - If
xxxx Sets the prime line on button 1, where
Enables VM Softkey feature for VM Ports only
IP P
WITH
ROTIMS
217
Advertisement
Chapters
Table of Contents
Troubleshooting
