Configuring Univerge Um8500 For The Integration - NEC UNIVERGE UM8500 Integration Manual

Configuring
UNIVERGE
UM8500 for the
integration
UNIVERGE UM8500 I
128
After ensuring that the messaging system server is ready for the integration by
completing all appropriate tasks in the Installation Guide, perform the following
procedure to confirm that the integration is enabled.
To select the INI file
1
Shut down UNIVERGE UM8500 before setting the following parameters.
Start > Programs > UNIVERGE UM8500 group > Edit Switch
2
Click
Utility
.
Ensure that the current phone system settings are correct according to the
phone system version and port types.
NOTE
The settings below apply to NEAX 2000 IVS/IVS2 or IPS.
Phone settings for OAI integrations with analog or T1 ports
Parameter
Manufacturer
Model
Specific version or
country
Integration method
Phone settings for OAI integrations with digital ports
Parameter
Manufacturer
Model
Specific version or
country
Integration method
Phone settings for OAI integrations with IP ports
Parameter
Manufacturer
Model
Specific version or
country
Integration method
3
If the current settings are not correct, select the correct ones and then click
Edit this switch configuration
listed in the title bar. Click
Update Voice Mail Now
4
Click
utility.
To update the INI file
1
Using Windows Explorer on the UNIVERGE UM8500 server, go to the
CommServer\IntLib directory.
2
Use a text editor to open the corresponding configuration INI file noted in the
previous procedure.
3
In the [Configuration] section, modify the NetIP1 value:
Replace the NetIPI with the exact IP address that the computer is using to
■
access the same LAN as the phone system. For example:
NetIP1=172.16.19.191.
G
NTEGRATION UIDE
Required setting
NEC
NEAX2000 IVS
All with analog boards and OAI
OAI
Required setting
NEC
NEAX2000 IVS
1300 series and above with digital
boards and OAI
OAI
Required setting
NEC
NEAX2000 IPS
Software release 8 or newer with OP
ports
OAI
. Write down the name of the ini file that is
OK
to close this window.
to apply the changes and close Edit Switch