Programming The Mitel 3300/Sx-3200 For Digital E&M Integration - NEC UNIVERGE UM8500 Integration Manual

Programming
the Mitel 3300/
SX-3200 for
digital E&M
integration
UNIVERGE UM8500 I
90
After connecting the systems, program the Mitel 3300/SX-3200 for digital E&M
integration.
NOTES
Voice mail ports within a voice mail-type hunt group can be
●
dedicated to message activation/deactivation by assigning and
applying a separate Class of Service option.
Class of Service option ONS/COV/E&M voice mail ports must be
●
enabled for members of a voice mail-type hunt group.
Attendant consoles are unable to receive a message waiting
●
indication.
Single line sets without message waiting lamps require the
●
Message Waiting Audible Tone Notification COS option enabled.
MWIs activated from an E&M voice mail port are considered to
●
be dialed message waiting type messages. These messages can
be deactivated from any E&M voice mail port or any system port
that is not in a voice mail-type hunt group.
Voice mail ports can be assigned to multiple voice mail hunt
●
groups.
To program the Mitel 3300/SX-3200 for digital E&M
integration
1
In the E&M Trunk Circuity Descriptor Assignment form, program the
parameters as shown in the following table:
E&M Trunk Circuit Descriptor Assignment settings
Setting
Address Signaling
Incoming Start Type
Minimum Flash Timer (100-250ms)
Maximum Flash Timer (200-250 ms)
Outgoing Start Type
Fake Answer Supervision after Outpulsing
Ignore Answer Supervision
Release Supervision Expected
Audio Inhibit Until Answer Supervision
Drop Digit Rcvr for Outgoing Audio Before Ans
Sup
NOTE
The Immediate (IMM) incoming and outgoing start type is the
preferred method of E&M signaling as it performs faster than
Wink.
2
In the Class of Service Options Assignment form for the E&M voice mail ports,
program the parameters as shown in the following table:
Class of Service Options Assignment settings
Setting
ONS/COV/E&M Voice Mail Port
Dialed Night Service
Message Waiting
Dialing Conflict Timer (2-5s)
Allow Trunk Flash
G
NTEGRATION UIDE
Value
DTMF
Wink or IMM
100
250
Wink or IMM
Yes
Yes
Yes
No
No
Value
Yes
Yes (optional)
Yes
2 (optional)
Yes