Integration
overview
UNIVERGE UM8500 I
268
UNIVERGE UM8500 uses the Open Application Interface (OAI) to integrate with
NEC PBX systems using a TCP/IP link between the UNIVERGE UM8500 server and
the PBX. OAI Integration can be used with IP lines and requires that the OAI
Integration server is installed.
Integration steps
Follow these steps to set up this integration.
Review the system and equipment requirements
1
Verify that all phone system and messaging system server requirements have
been met. See "Requirements"
Program the phone system and extensions.
2
See
"Programming the phone
Configure UNIVERGE UM8500 for the integration.
3
See
"Configuring UNIVERGE UM8500 for the
Install the OAI Integration Server software.
4
See
"Installing the OAI Integration Server
Configure the OAI Integration Server.
5
See
"Configuring the OAI Integration
Install and start the OAI service.
6
See
"Installing and starting the OAI
Requirements
The steps to set up the UNIVERGE SV8500 using OAI integration require the
following:
Phone System
A UNIVERGE SV8500 phone system.
●
A network connection to the voice mail server.
●
One IP-VPS port for each voice messaging port (TEC26) or one digital station
●
port for each voice messaging port.
UNIVERGE UM8500 server
A network connection with the phone system. A second network card on the
●
messaging system server to connect directly to the phone system is
recommended.
The Dialogic voice boards installed; see the Installation Guide for installation
●
details.
NOTE
For the latest information on supported voice boards for UM8500,
●
contact a sales representative.
No voice boards are required if IP-VPS or IP Terminal ports are used.
●
UM8500 installed and ready for the integration as described in the
●
Installation Guide.
OAI Integration server installed.
●
A system key that enables the integration and the appropriate number of
●
voice messaging ports.
G
NTEGRATION
UIDE
on page
268.
system"
on page
270.
integration"
software"
on page
Server"
on page
275.
service"
on page
278.
on page
273.
274.