Integration Overview; Integration Steps; Requirements - NEC UNIVERGE UM8500 Integration Manual

Hide thumbs Also See for UNIVERGE UM8500:
Table of Contents

Advertisement

Integration
overview
UNIVERGE UM8500 I
258
Use this section of the Integration Guide with the Installation Guide.

Integration steps

Follow these steps to set up this integration.
Review the system and equipment requirements.
1
Verify that all phone system and messaging system server requirements have
been met. See "Requirements," below.
Program the phone system and extensions.
2
See
"Programming the phone
Configure UNIVERGE UM8500 for the integration.
3
See
"Configuring UNIVERGE UM8500 for the
Test the phone extensions.
4
Test the phone extensions that are set up for the integration. See Appendix B,
"Testing the
extensions" on page 338.
Run the Learn Tones utility.
5
Run the Learn Tones utility to teach the messaging system the tones
associated with the phone system. See Appendix C,
tones" on page 340.

Requirements

The steps to set up the NEC SV8500 with Message Center Interface (MCI)
integration with a serial interface require the following:
Phone system
A UNIVERGE SV8500 phone systems with MCI:
One IOC serial port for the MCI data link connected to a serial port, COM1 is
the default, on the voice mail server with a PH-68 two-port cable and an RS-
232C CA-1 cable.
One or more of the following station ports set up as voice messaging ports:
Port type
Description
Digital
One digital station port for each voice messaging port.
IP-VPS
One IP-VPS port for each voice messaging port.
IP Terminal
One IP Terminal port for each voice messaging port.
UNIVERGE UM8500 server
The Dialogic voice boards installed; see the Installation Guide for installation
details.
NOTE
For the latest information on supported voice boards for UM8500,
contact a sale representative.
UM8500 installed and ready for the integration as described in the
Installation Guide.
A system key that enables the integration and the appropriate number of
voice messaging ports.
An available serial port, COM1 is the default.
G
NTEGRATION
UIDE
system"
on page
260.
integration"
"Learning phone system
on page
264.

Advertisement

Table of Contents
loading

Table of Contents