Programming The Phone System - NEC UNIVERGE UM8500 Integration Manual

Programming
the phone
system
See also
ETI-164, NEAXMail AD-40 Installation
and Programming, Volume 5, Issue 4
(March 1998)
NEAX 2000 IVS System Manual,
Volume II, Command Manual
If programming options other than those supplied in the following procedures are
used, the integration's performance can be affected.
NOTE
The following procedures are written with the assumption that you
will use a Customer Administration Terminal (CAT) or Maintenance
Administration Terminal (MAT) to program the phone system.
To program the digital voice messaging ports in the
phone system
1
Assign each voice messaging port to a Line Equipment Number (LEN) by
using command code 10.
2
Set or clear the function key assignments for each voice messaging port by
using command code 90, YY = 00:
3
Enable tone ringer on function key number 16 for each voice messaging port
by using command code 90, YY = 01.
4
For each voice messaging port, assign the prime line number to the voice
messaging port by using command code 93.
5
Assign all the voice messaging ports to a Uniform Call Distribution (UCD)
group by using command code 17, Y = 0.
6
Designate the pilot number for the UCD group that contains the voice
messaging ports by using command code 17, Y = 1.
NOTE
The pilot number must be a phantom single line extension. A
phantom single line extension is an analog extension assigned, by
using command code 10, to a LEN with no card in the slot.
7
Assign the UCD pilot number of the voice messaging ports to a UCD group
number by using command code 17, Y = 2.
8
Designate each voice messaging port as a digital voice messaging port by
using command code 13, YY = 24.
9
Assign the UCD pilot number of the voice messaging ports to a tenant
number by using command code 51, YY = 15.
10
Enable a periodic recording tone to be sent out from the phone system on
Live Record by using command code 08. Set basic feature number 109 to
be sent
.
11
Enable the message waiting service on each phone that is using UM8500 by
using command code 13, YY = 03.
To program the Dterm phones that use Live Record
For each Dterm phone that uses the UM8500 Live Record feature, perform the
following steps:
1
Designate the following function key assignments by using command code
90, YY = 00:
2
Assign the prime line number to the UCD pilot number of the voice
messaging ports by using command code 93.
NEC NEAX 2000 D D (D82)
WITH IRECT IGITAL
to
109