Integration
overview
UNIVERGE UM8500 I
26
Use this section of the Integration Guide with the Installation Guide.
Integration steps
Follow these steps to set up this integration.
Review the system and equipment requirements.
1
Verify that all Cisco CallManager and UNIVERGE UM8500 system
requirements have been met. See "Requirements," below.
Set up Cisco CallManager.
2
See
"Setting up Cisco
Install and configure the TAPI service provider on the
3
UNIVERGE UM8500 server.
See
"Installing and configuring the TAPI service
Requirements
UNIVERGE UM8500 installed and ready for the integration as described in
●
the Installation Guide.
A system key with the integration type set to "TAPI" or "Multiple," with the
●
appropriate number of voice messaging ports enabled.
Cisco CallManager software version 3.05 or later.
●
Cisco Unity-CM TSP version 6.0(2) or later.
●
A gateway compatible with Cisco CallManager.
●
Cisco licenses for all phone lines, IP phones, and other H.323 compliant
●
devices or software that will be connected to the network, as well as one
license for each port.
IP phones.
●
A LAN connection at each location where an IP phone will be plugged into the
●
network.
G
NTEGRATION
UIDE
CallManager"
on page
30.
provider"
on page
36.