Configuring Univerge Um8500 For The Integration - NEC UNIVERGE UM8500 Integration Manual

Configuring
UNIVERGE
UM8500 for the
integration
After ensuring that the messaging system server is ready for the integration by
completing all appropriate tasks in the Installation Guide, perform the following
procedure to confirm that the integration is enabled.
To confirm that the integration is enabled
1
In Internet Explorer, go to the UM8500 Administrator
(http://<server name>/saweb)
System Licensing
2
Go to >
3 Integration
In the
IP Protims
4
If the setting is not
necessary system key.
System Switch
5
Go to >
following table.
If the settings are incorrect, integration features might not be enabled.
Phone system settings
Parameter
Manufacturer
Model
Switch Software Version
Integration
NOTE
The software version used depends on the phone system settings.
Check the parameter ASYDL 672. If bit b1=1, the software version
must be "IP Protims ports display like DTERM_E". Otherwise, the
software version must be "IP Protims ports display like
DTERM_III".
6
Enter the MWI analog codes that the SV7000/SV7000MPS phone system uses
for turning the phones lamps on and off. Save the changes.
7
Stop UNIVERGE UM8500.
8
Run VOIPAdmin.exe from Commserver\Utilities folder.
The VoipAdmin Tool appears.
9
Enter IP address of the phone system.
10
Set the general functionality for the ports as VPS and enter the VPS number.
11
Under Manage ports, click
Enter the Extension, Password, and VPS channel for each port.
■
12
If the system uses one or more IP PADs, under Manage Gateways click
Enter the IP Address and set the Has DSP to 0 for each gateway.
■
OK
13
Click to save the changes and then close VOIPAdmin.
14
Start UNIVERGE UM8500.
15
In Internet Explorer, go to the UM8500 Administrator
(http://<server name>/saweb)
NEC UNIVERGE SV7000/SV7000MPS
.
Licensed Features
>
box, confirm that the setting is
, contact a sales representative for the
. Confirm that the settings match those in the
Required setting
NEC
UNIVERGE SV7000/
SV7000MPS
IP Protims ports display like
DTERM_E
IP Protims ports display like
DTERM_III
VOIP-Protims
Add
to add a new port.
.
IP P
WITH
.
IP Protims
.
Add
195
ROTIMS
.