Speed Calling - System; One-Touch Speed Calling Setting Using Spd Set Soft Key - NEC UNIVERGE SV9500 User Manual

SPEED CALLING - SYSTEM

• TO SET SPEED CALLING - SYSTEM
KEY
(ONE-TOUCH SPEED CALLING KEY)
STEP 1: Press
Feature
STEP 2: Press a desired One-Touch Speed Calling
key. The LCD displays previously stored dig-
its.
STEP 3: Dial the Speed Calling – System Access
Code and the abbreviated call code.
STEP 4: Press
Feature
SPEED SET
1:25 PM MON 11 MAY 2015
• TO OPERATE FROM SPEED CALLING-
SYSTEM KEY
STEP 1: Press the Speed Calling – System key.
1:25 PM MON 11 MAY 2015
STEP 2: If the DT830G does not have the "Speed Call-
ing – System" key, dial the Speed Calling –
System Access Code, then the abbreviated
call code.
. lamp lights red.
Feature
again. lamp goes off.
Feature
XXXX
ONE-TOUCH SPEED CALLING SET-
TING USING
SPD SET SOFT KEY
You can add, edit, or delete a One-Touch Speed
Calling key using programmable Line/Feature Key or
SPD Set key. When using SPD Set soft key, One-
Touch Speed Calling can be set when the terminal in
off-hook status (idle), otherwise, it is invalid.
Note
SPD Set is available for SV9500 V2 or later.
Note
SPD Set is configured at the installation stage.
To Add the One-Touch Speed Calling Key
with SPD Set Key as New Data
STEP 1: Press the SPD Set key.
1:25 PM MON 11 MAY 2015
SPD Set
STEP 2: Press the desired One-Touch Speed Call-
ing key.
Push Speed Calling Key
1:25 PM MON 11 MAY 2015
SPD Set
122
Mic NoDist
Mic NoDist