Field Installation Of Options; Installation Of Input Plate Options; Installation Of Line Power Shield For Adjustable Frequency Drives - Danfoss VLT HVAC Drive FC 100 Instruction Manual

4 How to Install

4.4 Field Installation of Options

4.4.1 Installation of Input Plate Options

This section is for the field installation of input option kits available for adjustable frequency drives in all D and E frames.
Do not attempt to remove RFI filters from input plates. Damage may occur to RFI filters if they are removed from the input plate.
NOTE!
Where RFI filters are available, there are two different types of RFI filters depending on the input plate combination and the RFI filters
4
interchangeable. Field installable kits in certain cases are the same for all voltages.
380–480 V
380–500 V
D11
E7 FC 102/ 202: 450 hp [315
kW]
FC 302: 335 hp [250 kW]
FC 102/ 202: 500–600 hp
[355–450 kW]
FC 302: 450–550 hp
[315–400 kW]
NOTE!
For further information, please see the Instruction Sheet,

4.4.2 Installation of Line Power Shield for Adjustable Frequency Drives

The line power shield is for installation with D and E frames and satisfy BG-4 requirements.
Ordering numbers:
D frames: 176F0799
E frames: 176F1851
NOTE!
For further information, please see the Instruction Sheet,
4-30
Fuses Disconnect Fuses
176F8443 176F8441
176F0253 176F0255
176F0254 176F0256
175R5795
175R5923
®
MG.16.A1.22 - VLT is a registered Danfoss trademark
VLT HVAC Low Harmonic Drive Instruction
RFI RFI Fuses
176F8445 176F8449
176F0257 176F0258
176F0257 176F0259
Manual
RFI Disconnect
Fuses
176F8447
176F0260
176F0262