Table 17-9 Trace Command Summary - Keithley 6430 Instruction Manual

Table 17-8 (cont.)
SYSTem command summary
Command
:SYSTem
:TIME
:RESet
:AUTO <b>
:TIME?
:MEMory
:INITialize
:LOCal
:REMote
:RWLock <b>
:RCMode <name>
:RCMode?
:MEP
[:STATe]?
:HOLDoff <b>
Table 17-9
TRACe command summary
Command
:TRACe|:DATA
:DATA?
:CLEar
:FREE?
:POINts <NRf>
:ACTual?
:POINts?
:FEED <name>
:CONTrol <name>
:CONTrol?
:TSTamp
:FORMat <name>
:FORMat?
Note: :SYSTem:PRESet and *RST have no effect on the commands in this subsystem.
Description
Timestamp:
Reset timestamp to zero seconds.
Enable/disable timestamp reset on exiting idle.
Query timestamp.
Initialize memory:
Initialize battery backed RAM.
Take unit out of remote (RS-232 only).
Put unit in remote (RS-232 only).
Enable or disable local lockout (RS-232 only).
Set auto range on compliance mode (SINGle or
MULTiple).
Query auto range on compliance mode.
Path to 488.1 protocol (Appendix G).
Query protocol (1 = SCPI, 0 = 488.1).
Enable/disable NDAC hold-off.
Description
Use :TRACe or :DATA as root command:
Read the contents of the buffer (data store).
Clear readings from buffer.
Query bytes available and bytes in use.
Specify size of buffer (1 to 2500).
Queries number of readings stored in the buffer.
Query buffer size.
Select source of readings (SENSe[1], CALCulate[1],
or CALCulate2).
Specify buffer control mode (NEVER or NEXT).
Query buffer control mode.
Path to set timestamp format:
Select format (ABSolute or DELTa).
Query timestamp format.
SCPI Command Reference
Default
parameter SCPI Memory
OFF
✓
✓
SINGle
OFF
Default
parameter
Note
17-19
SCPI
✓
✓
✓
✓
✓
✓
✓
✓