Keithley 6430 Instruction Manual page 36

1-4 Getting Started
Model 237-TRX-T Adapter — This is a 3-slot male to dual 3-lug female triax tee adapter
for use with triax cables.
Model 7078-TRX-BNC Adapter — This is a 3-slot male triax to female BNC adapter. This
adapter lets you connect a BNC cable to the triax input of the Model 6430.
Model 237-TRX-TBC Connector — This is a 3-lug female triax bulkhead connector with
cap for assembly of custom panels and interface connections.
General purpose probes
Model 8605 high performance modular test leads — Consists of two high voltage
(1600V) test probes and leads. The test leads are terminated with a banana plug that has a
retractable sheath on each end.
Model 8606 high performance probe tip kit — Consists of two spade lugs, two alligator
clips, and two spring hook test probes. (The spade lugs and alligator clips are rated at 30V
RMS, 42.4V peak; the test probes are rated at 1000V.) These components are for use with high
performance test leads terminated with banana plugs, such as the Model 8605.
Model 8607 High Performance Banana Cables — Consists of two high voltage (1000V)
banana cables. The cables are terminated with banana plugs that have retractable sheaths.
The following test leads and probes are rated at 30V RMS, 42.4V peak:
Models 5805 and 5805-12 Kelvin probes — Consists of two spring-loaded Kelvin test
probes with banana plug termination. Designed for instruments that measure four-terminal
resistance. The Model 5805 is 0.9m long; the Model 5805-12 is 3.6m long.
Model 5806 Kelvin clip lead set — Includes two Kelvin clip test leads (0.9m) with banana
plug termination. Designed for instruments that measure four-terminal resistance. A set of
replacement rubber bands is available (Keithley P/N GA-22).
Model 8604 SMD probe set — Consists of two test leads (0.9m), each terminated with a
surface mount device "grabber clip" on one end and a banana plug with a retractable sheath on
the other end.
Low thermal probes
Model 8610 low thermal shorting plug — Consists of four banana plugs mounted to a
1-inch square circuit board, interconnected to provide a short circuit among all plugs.
Model 8611 low thermal patch leads — Consists of two test leads (0.9m), each with a
banana plug that has a retractable sheath at each end. These leads minimize the thermally-
induced offsets that can be created by test leads.
Model 8612 low thermal spade leads — Consists of two test leads (0.9m), each terminated
with a spade lug on one end and a banana plug that has a retractable sheath on the other end.
These leads minimize the thermally-induced offsets that can be created by test leads.